Installing cable tray in existing slab1/25/2024 ![]() ![]() ![]() Feed the fish tape from the start to the endpoint and attach the wire.Drill a hole near the wall at your starting point and another hole at your endpoint in the floor.For multiple connection points, drill additional outlet box holes and feed the wire through each one as needed.įor running speaker wire or networking cable to the middle of a room:.Feed the wire through the outlet box, attach the box to the wall, then terminate the wires.Leave plenty of extra length for connections. Pull the wire until several feet protrude from the outlet box hole.Attach your electrical wire to a fish tape and feed it through the hole until it reaches the outlet box opening.Go to the attic or basement and drill a hole through the top or bottom wall plate in the same stud cavity.Once the route looks clear, cut a hole in the drywall for the outlet or switch box using a drywall saw.Otherwise, use a stiff wire to feel for obstructions. Drill a hole in the drywall and insert a small inspection camera, if available, to examine the route.Turn off the power and use a stud finder to locate an open cavity between studs for the outlet or switch box.If clear, you are ready to start running your wires.įollow these steps to fish your wiring through walls: Lighted Magnifying Glass That Stays Putĭrill a small pilot hole where the outlet or other termination point will be, and use a coat hanger to feel around inside the wall cavity for blockages.Best Lawn Care Service for Service Dogs. ![]()
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |